Papertowel Holder For Pegboard Using Drywall Anchors
Description
This is a remix of thing 488207. For standard pegboard (1 inch spacing from each hole-center to the next hole-center) I like to mount using drywall anchors and screws. The plastic hooks just don't cut it for me because you usually have to print the design with supports, which I despise, and they snap off easily or are difficult to insert into the pegboard. This design prints without any supports. The drywall anchors rest inside the recessed holes nicely. If your drywall anchors are too long, simply snip about a 1/4 inch off the end. (Most people have their pegboard about 1/2 inch spaced from the wall.) Use screws about 1/2 inch to 3/4 inch long depending on your pegboard-to-wall gap. If you need drywall screws or anchors, you can find some at the link below: https://amzn.to/3LpMsva
Statistics
Likes
0
Downloads
0