Geeetech Mizar S, Pro Direct Drive Bracket
Description
Direct Drive Bracket for the Geeetech Mizar S. Will work on any 3D printer with similar hot end like the Mizar and Mizar Pro Most messurement were obtained from datasheets adn a few unavailbel ones from hand measurements and scanning my own brackets It took me to Version 4 to get it just right and a test print was perfect. thats the last picture. you will need to buy extras with this Pancake Stepper motor, 22mm (original is too big) Optional replacement Extruder if you dont was to dismatle original so you can undo mod. M3 Heat Set Nut M3x6 or M3x8 machine screw Optional 7mm masonry drill bit (need the masons bur on end to get 7.125mm hole) PTFE Tubing (Capricon) 4mm PTFE push fit connector (Optional if using original extuder) You will insert the wheel bushes into the bracket and re use them, and assemle just as you disasembled the hot end gantry wheels.
Statistics
Likes
0
Downloads
0