30mm fan heatsink mount, using stock extruders ~ 95C for heat chamber chambefs
Description
Use metal strap and tool to secure X and Z steppers, then slide on printed 30mm fan holder then slip in fan and push the rest as needed. Sink and fan will keep the motor healthier and running longer, I was printimg at >90C for a couple years , and these sinks and fans, kept the stepper motor healty the whole time. Only plastic i got to work well polymaker tough PC. 248C, 95C,30mm/sec 30 min dry time enabled with 5mm/sec min, and lift enable
Statistics
Likes
0
Downloads
0