Pill Bottle Holder
Description
Shout out to user IOI671701 (https://www.thingiverse.com/ioi671701/designs). While this isn't a remix, that design was definitely the inspiration for this one. PRINT AT ABOUT 102%. While this is for pill bottles with a 32mm base diameter, I didn't take into account the labels. Adds just enough room to make it perhaps too snug. I just needed something to keep my medicine shelf in order. Made this to stack them as close together as possible, keeping them upright and from falling all over the place. Designed to use as little filament as possible. Went ahead and printed at 100% for a bit of sturdiness.
Statistics
Likes
0
Downloads
2