Hunting GoPro tree mount
Description
This was designed to screw to a tree so you can self record your hunt. It prints in a 2 piece design. You will need M5x20 screws and nuts. It will also help to have the gopro screw to mount the camera, but you can use the M5 screw if you don't have one (you'll just need an allen wrench in the field). I print this in PETG so that it's strong, yet a little flexible. The thin arms will bend a little toward the tree as you put screws in it. The swivel requires you to insert a pause (or filament change because my printer acts up with a pause at height command) on the layer before it closes up the M5 nut hole. Once paused, you must press in an M5 nut. These go in HARD, but are extremely secure onces pressed in. Make sure its all the seated so your nozzle doesnt run into it. Once done, screw the swivel to the mount with an M5x20 bolt and take it to the woods!
Statistics
Likes
0
Downloads
0