Waterchange Set Aquarium [Reworked]

Description

A reworked Modell of my previous Aquairum Waterchange Set. [Old Modell]: https://www.thingiverse.com/thing:5984857 Requirements: Water Tap connection Diameter: max. 25mm correct tap design required where its possible to add the clamp from above ---------------------------------------------------------------------------------------------------------------- Improvements: increased waterflow, especially when draining the aquarium less use of filament improved overall functionallity (especially switching between flow directions) only one sealing ring required connection is now more waterproof possibility of easy change the clamping height due to the seperate clamping part ---------------------------------------------------------------------------------------------------------------- Purchase parts you'll need: 1x sealing washer 30x3-3,5mm (inner diameter 20mm) water hose 12/16 ---------------------------------------------------------------------------------------------------------------- Print Settings i've used: printed with PETG 0.2mm layer height 100% infill only part that needs support is the “Y-Part” (see Slicer-Pictures) ---------------------------------------------------------------------------------------------------------------- Steps to perform for waterchange: connect adapter to the water tap make sure the outlet is closed “Plug_part1” + “Plug_part2” turn on watertap until the hose into the aquarium is completely filled with water close watertap and open outlet - if your aquarium waterline is over the outlet, water should now drain out of the aquarium close outlet and open watertap to refill the aquarium

Statistics

Category

Tags