Lithophane stand (125mm and 150mm)
Description
Remix of a 150mm straight lithophane stand i found on here. The original design works well, i just tweeked it a little. The original version was a little too tall for some of my prints (i.e. covering too much of the bottom of the picture), so i brought the height, of the part that holds the litho, down a bit. Also made the opening a tad smaller, so the lithos would still stand upright. The slot for the pictures to sit in was brought down to 3.7mm, so keeping the print to around 3mm thick should still give a good viewing angle as well as leaving a little room to spare for thicker prints. Also took off a little bit of width to add a 125mm version.
Statistics
Likes
0
Downloads
0