Hoover Vacuum Cord Wrap
Description
Replacement part for Hoover U81xx Vacuums. This is a replacement part for my 20 year old Hoover U8130 WindTunnel V2 Bagless Upright Vacuum. It fits all models shown here (part #15 in the drawing). https://www.usavacuum.com/Hoover-U8130-WindTunnel-V2-Bagless-Upright-Vacuum-Parts-s/1382.htm To remove the broken part: - remove #49 Final Filter Door (pops off) - remove #42 Final Filter - remove screws #34 (qty 2) - remove screws #29 (qty 2) - remove #35 Front Panel - squeeze the cord wrap tabs on the inside and push out the back The new part snaps right in. I printed this flat (as shown), but there's a good chance it will snap due to layer orientation. It would probably be much stronger if printed on its side.
Statistics
Likes
0
Downloads
1