ANBERNIC RG505 Stacked Triggers
Description
Stacked trigger buttons for ANBERNIC RG505 retro console. They feel very good. Definitely better the the original ones. They might require a couple of tries with sanding and adjusting small imperfections at first, but once you do that is works really well. Supports needed. You will get the best results from a resin printer although I printed mine on FDM and they turned out quite nice. I suggest printing R1 and L1 upside down (it helps with hiding an ugly layer printed on supports). You may find the mounting hole a bit to tight, but you can easily widen it a bit with a screwdriver or something. Look out for any imperfections after printing because they might make the buttons not work perfectly. If you find any stringing or some other defect try getting rid of it with sanding paper or knife. The mounting process is really straight forward. You just remove the back panel and then you remove old triggers. Put on the new ones in place and close the console back panel. I suggest watching this teardown first: https://www.youtube.com/watch?v=nAfsIgFF77Q&pp=ygUPcmc1MDUgdGVhcmRvd24g If the buttons don't go back after clicking that's probably the mounting hole being to tight. If you have any suggestions for improvement feel free to comment.
Statistics
Likes
0
Downloads
0