hat_hanger_XL
Description
Needed to extend the portion that contacts the hat (40mm) since the "cowboy" hat this was to be used for had a front to back curve that keeps it from sitting flat against the wall. I also added a countersunk hole for a #8 panhead bolt for mounting using a wall anchor if you prefer that over tape. Hole is 4mm in diameter for bolt and 10mm countersink for the head. Might be an interference fit so the bolt might need to be threaded into the part. I am a total novice on Fusion360, so the hole is almost centered...shouldn't make a difference when mounting. I used a raft when printing as I was getting curling on a corner.
Statistics
Likes
0
Downloads
0