slim slide on v6 fan mount single or dual 30mm fan
Description
This is a improvement for the standard v6 fan mount and can fit in almost any v6 heat sink arrangment, 28mm wide can just slide under the mount on to the v6 heat sink, if you use two heat sink fans, I never have heat creep problems since started using this over a year ago , including 100C heat chamber printing or super soft plastics (that advise not to use a all metal hot end) 83A TPI, etc. I am only using cheap 5$ V6 clones standard stainless steal heat brakes and 30mm pusher and puller heat sink fans. Used with 5$ titan clones, and sherpa's This will also work better than than the stock fan mount for single fan if you choose. My HVAC peeps will recognize how big of a increase in CFM and decrease in diffusion by adding puller fan. the mount can slip under a titan extruder and standard V6 mounts, then I use angled part cooling fan if needed which is in my designs. M3 threaded screws are overkill and leave large holes and rethreading you have issues. self threading M2 x16mm screws with PC washers work much better to mount the fans, so holes are sized for m2 self threading. printable washers are also in my designs. I use polymaker pc max for this , tolerated 100C chamber 110C bed temps etc.. without softening. These print thin and strong and tolerate repeated screw removal and replacement. It's the only plastic that I know works for this design. my other go to Prilince PC-CF extrahard softens in a heat chamber at 90C or so I stick with polymax PC .4 noz .2 layer , 250C 90C 30mm/sec 30sec min dry time each layer 5mm/sec min speed, enable lift.
Statistics
Likes
0
Downloads
0