Anycubic Wash and Cure 2 stacking mod
Description
A stacking arrangement for the Anycubic Wash and Cure 2 - mainly designed to shorten the time spent washing and curing dental models. Print with no top or bottom layers (set this in your slicer) set at 6% grid infill (using grid pattern) for the stack base and 8% for the curing base. Set the top/bottom line directions to (0,90) Obviously change this to infill of your choice with top and bottom layers turned on for the dividers. Place the flat section of the design flat on your build plate - no supports needed. Tolerance is built into the design for the fit of the dividers - I get a friction fit but put some superglue in the holes when assembling - just to be sure!
Statistics
Likes
0
Downloads
0