Anycubic Kobra Neo dual z belt tensioner (2020 extrusion top required)
Description
this is for an Anycubic Kobra Neo that is doing a dual z axis upgrade using a belt, not dual motors.The benefit of belts is that you never have to deal with synchronizing motors / heights of the X gantry or adjusting the vref on your board, leading to the risk of shorting out something Required! - 2020 x 320mm aluminum extrusion, super cheap on aliexpress but you have to cut it with a hacksaw - im using a 610mm closed loop belt (6mm wide) - toothed roller (no ball bearing required) for 6mm belt - M4 x 10mm hex screw (x2) - M4 nylock nut - M4 t-nut (x2) - M5 x 20mm hex screw (both holes need to be tapped, not drilled out) Start by mounting in the middle of the extrusion. Move it to one side to tighten the pulley For a complete dual z belt project, refer to these thingiverse files ive made: https://www.thingiverse.com/thing:6180376 https://www.thingiverse.com/thing:6210211
Statistics
Likes
0
Downloads
0