Animatronic Halloween Crow
Description
This is a remixed crow animatronic. Code is currently not available, but should be fairly easy to setup using danman's crow, and adding the additional servo for the beak. Pictures will be added after completion. Changes Head: Made hollow Precut holes for 5 mm leds Precut wire hole Split into lower beak, base, and top sections Added servo that can open and close beak Body: Made hollow Precut servo hole and wire channel Opened up, and added holes for magnets Feet: No changes, not included Tail: No changes, not included Servo holes are made to fit 24x12 mm servos Assembly Insert servo into bottom of head. Insert lower beak into posts, hold in place with 2mm rod Run music wire or similar through holes in jaw, connect to servo arm Wire leds for head Insert head base + beak assembly into head. Squeeze the sides of the jaw, it should pop through all the way Screw/glue base and head together *Note* You may need to remove additional material from the bottom of the opening in the head for smooth movement Install servo into top of body, connect servo arm, glue or screw everything together as needed. Future: I plan on adding pins to the legs and body to make assembly easier. I also plan to hollow out and add magnet holes to the tail. Until that happens follow danman's instructions in the original.
Statistics
Likes
0
Downloads
1