CR2032 coincell holder with on off switch
Description
# Summary This thing can hold a CR2032 battery and has an integrated switch, to turn power on and off. Especially useful for small DIY project where you need to light LEDs using a CR2032. # Printing - I uploaded them in a recommended print position - No special settings required - Take care that your printer is level correctly (you do not want an elephant foot). # Assembly - You need 2 wires with 1.5 mm diameter. - Stick the wires in the holes and <b>secure them with super glue</b>. - Slide the top part over the bottom part but and wait for the satisfying snap sound. - Do not forget the battery ;) # Why the Remix? So I liked the idea of the original, but a few things were missing and I always had loose contact, so I did the following to improve the design: - The parts now snap together with an interlocking mechanism. - The bottom part has a cut out and a little raise, which presses the wire against the battery - The top part has a little slope which presses the battery against the wire for better conntact
Statistics
Likes
0
Downloads
0