Holley Screen vent Mount - Customized for dash of 94-02 era Trans Am
Description
94 - 2002 Trans Am Terminator X Screen Mount that covers vent. It is contoured to match the dash. There is a non-angled version and an angled version that faces the driver better. Parts needed to complete project: 1 x 6 inch bolt 2 x matching nuts to lock on the vent cup Heat resistant Epoxy Glue. *Note for those tubes with two glues that mix when you squeeze them out.... mix them again, and VERY well. I did not do that the first time and it never setup and I ruined a print. Once the parts are printed, Glue the bolt into the hole on the back of the mount. I tried creating a printed screw for this but it was never as durable as I wanted it to be. Finally to finish the project I just glued in a bolt which ended up working perfectly. We ended up removing the vent slats but I am sure the bolt could fit through maybe without causing any issues if you did not want to do that. Then fit the cup over the vent end and secure with the two remaining nuts.
Statistics
Likes
0
Downloads
0