Remix: Milwaukee M18 QuickCharge 3.0 USB Adapter by Zoggee
Description
The original model of this was very well designed, but incomplete. I just made the finishing touches. Needed materials: -https://www.amazon.com/gp/product/B0776PY5JK/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1 -https://www.amazon.com/gp/product/B087RHWTJW/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1 -(4) M3x20 screws -small gauge wire -some way to splice wires You'll also need to do a bit of soldering. First, you'll need to remove the insulation from the red piggyback connectors. Next, you'll solder a short length of wire to the piggyback, try not to get the solder on the outside of the barrel. Then, straighten the piggyback connector so the spade is straight. Now you can fish the wire through the bottom to the middle section, do this for the + and - terminals. Solder a short section of wire to the USB modules. Place them into the middle section, they should stay in place once the lid is on. Now, connect all your wires however you'd like. I like using Wago lever locks (as pictured). Lastly, install the lid. All three swctions will be held together by the screws.
Statistics
Likes
0
Downloads
0