K8200 frame extension with spool holder
Description
I Had Some Trouble With Breaking Filament While Printing Higher Objects. I Think It'S Because Of The Low Temperature In My Workshop And The Small Radius The Filament Is Bent. So I Designed This Frame Extension To Get Some Distance From The Spool To The Extruder Inlet. It'S Basically A Socket For The Frame With A Slot-Compatible Extension On Top. The Right Side Is Extended To Allow A Spool To Be Mounted, The 3 Slots On The Other Sides Can Be Used To Mount Accessories. Future Extensions Planned: -Dust Remover Addon -Second Spool Mount On Rear Side (Only Longer Rod Needed) -Eventually: Webcam Mount -Eventually: Light Mount Printed In Pla With: -Concentric Top And Bottom Fill -2 Shells -3 Layers (Add 2-3 When You'Re Printing Slim) -10% Hex Infill (15 If You Expect More Than 2 Kg Weight) -No Support (Just Make Sure You'Re Printing Not Too Hot To Avoid Bridging Issues, I Used 190 Degrees With Good Results) The Fit Is Quite Tight, The 2 Screw Holes In The Base Were Not Needed In My Case. Inspired By #166023
Statistics
Likes
9
Downloads
0