Subaru WRX Pedal Spacer (2017 to 2021)
Description
WARNING, THIS IS UNTESTED, USE ON YOUR CAR AT YOUR OWN RISK. I AM NOT RESPONSIBLE IF YOU WRECK YOUR CAR BECAUSE YOUR PRINT BREAKS OR IF YOU HIT THE GAS PEDAL WHEN TRYING TO HIT THE BREAK PEDAL I thought 125$ for a pedal spacer is bs/it doesn't need to be made out of the worlds finest aluminum lmao. this will move your pedal forward 25mm, adjust left to right by +-6mm and adjust up and down by +-18mm Unsure if this will fit all of these model years, I only have my 2021 to test on. it should work on the base model WRX as well as the STI Make sure to view all the photos & this summary area for a full list of parts needed and print settings for maximum strength and safety OTHER WARNING, I HAVEN'T DESIGNED A STOPPER YET, SO DON'T FLOOR IT LMAO (Idk if it's really needed, but be gentle/don't slam it all the way down as it'll stress out the inside of the pedal rather than hit the stopper) Required Hardware: Two M6 x 35mm Hex Head Bolts Two M6 Nylon Locking Nuts the two factory M6 nuts off the car itself painters tape (to keep the bolts from falling into the chassis Required tools, 10mm socket (whether its on a screwdriver or on a ratchet, either is fine. A spanner/standard wrench wont fit) deep socket + extensions recommended (the top bolt is a pain to get to)
Statistics
Likes
0
Downloads
3