Ender 3 Micro Swiss NG Cable Strain Relief
Description
Remix of [Ender 5 Plus Micro Swiss NG Cable Strain Relief by Tuna](https://www.printables.com/model/397859-ender-5-plus-micro-swiss-ng-cable-strain-relief) on Printables. Original was slightly too thick to use with the CR-10/Ender3 NG variant and would cause binding of the V rollers. Rather than thin it out, potentially losing some rigidity, I added notches to allow it to sit flush to the back plate. I printed flat with 3 walls and 15% infill. I was able to install by removing the top 2 V rollers and pressing it on. The fit was quite snug, but I was able to get it on by hand. Just make sure you're putting both sides in at the same time. Use with 3mm zip ties.
Statistics
Likes
0
Downloads
0