Harry Potter hue forge filament painting
Description
Only filament swaps are needed, no MMU or AMS is required, but AMS makes it a bit easier. To get the intended look use the filament swaps as described. You can change the colors to get the desired look, but I do not recommend adjusting the other settings. Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm Filaments Used: SILK PLA mika3d silk black Transmission Distance: 5 SILK PLA mika3d silk sapphire blue Transmission Distance: 5 SILK PLA mika3d silk red Transmission Distance: 5 SILK PLA mika3d silk salmon orange Transmission Distance: 5 Swap Instructions: Start with silk black At layer #9 (0.8mm) swap to silk sapphire blue At layer #10 (0.88mm) swap to silk red At layer #17 (1.44mm) swap to silk salmon orange for the rest. If you do not have this filament you can use any red, blue, black , and a peach or skin color filament. to get a similar look. The layers are thin, so the color below shows through to give it the desired look. I'm sure you can achieve the same or better looks with basic PLA vs silk. I just like things shiny. Make sure to post the image of your make. The pictured image was printed on my P1P on ludicrous mode. I'm sure the quality would be better if it was printed at standard speed.
Statistics
Likes
5
Downloads
21