GEPRC CineLog35 V1/V2 front rear LED Lights
Description
Hey Makers, This little design add front and rear light for your Cinelog35 V1 or V2. Look at the wiring diagram in the picture. These lights use WS2812 RGB 3.5mm width LED strip divided into two parts - front and rear light connected to flight controller. Length of led strip is 5x WS2812 chip for each Light! Use TPU or same other flexible filament. Prints design of mount in default orientation with using supports. After printing, stretch the wires through the mount and solder wires with the LED strip and fit into the mount. The whole assembled lights then install into the drone frame a configure it. Led strip buy [HERE](https://www.aliexpress.com/w/wholesale-ws2812-chip-3.5mm-strip-fpv-racing.html) or [HERE](https://www.aliexpress.com/item/1005003824598876.html)
Statistics
Likes
0
Downloads
2