Lego Speed Champions Stacking Stand
Description
I designed a stacking stand for Lego Speed Champions specifically 8 wide however 6 wide may work also. This stand is a one piece print per level design. I recommend stacking 7-8 levels max including the base because the stand will start to sway left or right, could not figure out why yet. I may update and add a newer version allowing for reinforcements for the pillars. The stand allows you to put a minifigure in front of the car if desired. I recommend printing using only a support under the part where the minifigure stands and using support blockers under the 4 square holes under the stand. Supports are not necessary however the bottom of the minifigure part will look a little unfinished but it should still function. The stand was designed in Solidworks Send recommendations/questions to my Lego Instagram account @j.p.builds I hope you like the stand and find it works well for you. I'm a college student in Florida working when I can so if you have and would like to leave a tip, that would be greatly appreciated. Cashapp: $johnnypoole02 Venmo: johnny02young
Statistics
Likes
0
Downloads
1