Project Enclosure 100 mm x 150 mm x 40mm
Description
Project Enclosure 100 mm x 150 mm x 40 mm - Separate compartments for power supply and electronics. - 4 versions with different combinations of vents and mounting holes. - Lid screws into M4 heat-set nuts. - Mounting holes are M5. - Rigid Grommet has more clearance for the walls of the case. The darker grommets in my photo are TPU 82A. - M4 and M5 Countersunk washers from my Countersunk Washer Library included. - Photos show an earlier revision with marginally different mount geometry, and without stress-relief rounding along the internal edges. - Expect an 8-12 hour print for the case plus 1-2 hours for the lid, depending on settings.
Statistics
Likes
1
Downloads
8