Flipper Zero - Minimalist WiFi Dev Board Case (GPS + SD)
Description
A minimalistic 3D printable case for the [Flipper Zero Wi-Fi Dev Board](https://shop.flipperzero.one/products/wifi-devboard). There are two variations of this case, a larger XL version and a normal size MD version. The XL version has a larger under-cavity for addons such as a GPS module. The MD version has a smaller under-cavity for minimal wiring. Both versions have antenna and/or Micro SD card slot options. ### Variations #### XL (17.75mm thick), 11mm under-cavity, GPS/additions capable: - **XL** > Fully loaded > Antenna mount > Micro SD card slot (by [justcallmekoko](https://www.tindie.com/products/justcallmekoko/wifi-dev-board-micro-sd-adapter/)): - XL_Full.stl | XL_Full.3mf - **XL** > Antenna mount only: - XL_Antenna_Only.stl | XL_Antenna_Only.3mf - **XL** > Micro SD card slot only (by [justcallmekoko](https://www.tindie.com/products/justcallmekoko/wifi-dev-board-micro-sd-adapter/)): - XL_SD_Only.stl | XL_SD_Only.3mf - **XL** > Barebones > No antenna mount or Micro SD card slot: - XL_Bare.stl | XL_Bare.3mf #### Normal (15mm thick), 8.25mm under-cavity for minimal wiring. - **MD** > Fully loaded > Antenna mount > Micro SD card slot (by [justcallmekoko](https://www.tindie.com/products/justcallmekoko/wifi-dev-board-micro-sd-adapter/)): - MD_Full.stl | MD_Full.3mf - **MD** > Antenna mount only: - MD_Antenna_Only.stl | MD_Antenna_Only.3mf - **MD** > Micro SD card slot only (by [justcallmekoko](https://www.tindie.com/products/justcallmekoko/wifi-dev-board-micro-sd-adapter/)): - MD_SD_Only.stl | MD_SD_Only.3mf - **MD** > Barebones > No antenna mount or Micro SD card slot: - MD_Bare.stl | MD_Bare.3mf ### Cover / Buttons - **XL/MD** > Cover - Cover.stl | Cover.3mf - **XL/MD** > Buttons - Buttons.stl | Buttons.3mf ### Assembly The case is designed to be printed in three parts, a top, buttons for the top, a bottom, and then screwed together using 4 x M3x16mm screws w/ 4 x M3 nuts. Place buttons in the top piece and install upside down so buttons don't fall out. ### Printing and assembly tips - Using supports when printing can help with the hex holes. - Printing the first layers slower also helps with the hex holes. - Print all pieces with 100% infill. - When the print is done trim with razor around edges so things fit nicely. - Use double sided tape to keep your GPS module in place. - Trim your buttons and make sure they slide nicely and stay put when inserted. - Trim your hex holes and do not force the screws heads in flush, they should slide in nicely. - Be careful not to pinch wires, use black tape to keep things in place if you need to. - If you're lazy like me but care about your board, use black tap to keep your GPS and board separated. See more designs on my GitHub here: https://github.com/CodyTolene/3D-Printing Enjoy!
Statistics
Likes
0
Downloads
10