CR-6 SE filament sensor distance for BMG
Description
Once I upgraded my CR-6 SE to BMG extruder, then I need make distance for filament sensor. Because BMG part is much higher for filament input. Sometimes Creality filament sensor works from both sides, so the design account with that (4 mounting holes, but only 2 diagonal are used for mounting in desired position). I put here also smal area for sponge, where you can clean dust or can oil a PLA filament. Just cut a piece of kitchen sponge. For mounting you will need buy longer screws (rather with countersunk head). Attached is also version 1 that is on photo. This version allows only one assembly position. On opposite side is the hook for 3-pin cable for the sensor, if you install it in CR-6 usual position.
Statistics
Likes
0
Downloads
0