KP5L_Spool_Holder
Description
I designed this spool holder for my KP5L with the intention of providing a more stable flow of filament because I had some jamming problems. It's not my best design, but it does its job perfectly. I hope it helps you, and you can print it without problems. I used PLA, but I recommend using PETG since it is more resistant. Print settings are flexible and depend on each user and printer, I used the following: Supports: NO Resolution: 0.20 Nozzle: 0.40 Bed temperature: 60 Printing temperature: 220 Print speed: 40mms Filling: 15% Thank you all and I hope it is helpful to many. If you share, I would greatly appreciate it.
Statistics
Likes
0
Downloads
0