Minn Kota Knurled Short Handle
Description
I broke/lost the handle to my minn kota endura 40lb c2. I wanted a shorter handle anyway since the motor is right behind my seat, so it worked out. Decent friction fit, but you can either add a few drops of glue or use the small countersunk screw hole. There is a 5mm indention that you can line up a small m4 or m5 bolt with, totally non-destructive if you get the length right. Full mountain aggro knurl, 30mm diameter (I'll double check, I may have decreased this a bit with the knurl) I printed hole side up, X and Y scaled to 100.5%. I never tried at 100, but it would probably be a hammer on since I decided not to design in a gap. If you don't want to screw or glue, I would do 100.1% or so on X and Y and press it on tight. Will add pictures later
Statistics
Likes
0
Downloads
0