the "NicoJ Flip" table tennis adapter for Quest 3
Description
The second adapter for Eleven Table Tennis for Meta Quest 3 -> the "NicoJ Flip" Advantages over the previous one: - lighter (46 g with screws, depending on print settings...) - lower center of gravity (less head weight) - the position of the controller's top plane is respected in relation to the hand-held position, which should improve tracking Print: All parts have to be printed. Print two handles and two thumbscrews. Two different handles are provided, large and small, print the size you prefer (print twice the chosen stl). Only handles need to be printed with support (supports are easy to remove). To improve weight, you can use low infill values, and just increase the values near the parts with around the screws. You can also reduce top and bottom layers, or wall numbers on handles for instance. Then you need two M4 screws and their nuts. Ideally, one 16mm and one 24mm screw, but larger sizes work. Installation: To install the controller, slide it from top to bottom in the upper left-hand section (this section can remain on the racket), then close it with the right-hand section and fit the two screws. Installation takes no more than 30 seconds with a little practice. I'd like to thank Joshua Cant for his advice on improvements and his help with test prints. PS You can use the setting 235063.3 in ElevenVR. Go to “Gears”, “Carrot, “Backup And Reset”, and then “Download” with the key.
Statistics
Likes
0
Downloads
0