Phone Stand
Description
Hello everyone. I made this foldable phone stand with Tinkercad. If you've used Tinkercad before you'll know it's quite hard getting things the way you want it. This fits phones with any width and length. Anyways, this is a one-piece print. You MUST print it on its side with supports. I played with settings on Cura and failed many prints to get the best settings to print this. Make sure to print with a Brim if you struggle with lifting. I'll attach my settings and also list them below. This is still a work in progress and would like to refine it more. Enjoy!
Statistics
Likes
0
Downloads
0