Simon Petrikov glasses
Description
# Simon Petrikov glasses Print two temples and a single frame, **no supports needed**. You may have some troubles printing the joint of the temples, but from 4 I printed out, only 1 turned out wrong. After printing, **just snap them in place** (make sure you make both ends face the same direction). The frame has a tiny notch inside to put in some **transparent plastic as glass**. You'll need to cut a couple of circles of ~31mm in diameter. <u>_Notes:_</u> The glasses may be a bit wobbly due to clearances. Also, I had to curve the temples' ends for them to fit better behind my ears, but you can do that easily with some hair dryer. I found it better than trying to print them curved and have a nasty finish due to supports, but you may also try that if you want (Fusion 360 file attached). Hope you like it. Cheers :)
Statistics
Likes
0
Downloads
0