Salanki VR gunstock remix
Description
Changes Changed Stock tube to fully printed to reduce weight, applied a 15 degree slant on the tube body to strengthen the Z-axis. Added a piece of printed magnet support inside the magnet cup to adapt smaller magnets. Modified the muzzle piece to make it easier to print and harder to break, also reducing overall length a tiny bit. Flattened the designs on the main body for an easier print, removed the unnecessary sight mount on top of the body. Added more lines onto the buttstock plate for more fraction when shouldering the gunstock HOW TO PRINT Print the buttstock parts as is, pretty obvious which side to print on. Print the muzzle with the front side touching the build plate (the flat side). Print the stock tube with the rear side on the build plate (the side closest to your sholder) the tube should be slanted when placed correctly. Print the main body with the rear square side on the build plate. you may want to use a brim due to small surface area on the build plate. You might want an 4 layer wall due to the thinner body, also use 35%-50% infill. No supports are needed for all parts. NON-PRINTED PARTS M3x40mm caphead for buttstock lever 0.5x6x20mm spring for buttstock lever M3 nut for buttstock lever 2x M3x5mm caphead for buttstock cusion 2x M4x18mm wood screw for controller mounts 2x Thin one-sided rubber sticker for controller mounts 1/2’’ 400mm steel pipe for barrel Magnets 28 x 5mm 55 LB Force pot magnet for left hand mount https://www.amazon.co.uk/dp/B07Q5R1ZLJ?psc=1&ref=ppx_yo2ov_dt_b_product_details 32 x 8mm 44 kg Force pot magnet for right hand mount https://www.first4magnets.com/countersunk-c41/32mm-dia-x-8mm-thick-x-5-5mm-c-sink-n42-neodymium-pot-magnet-44kg-pull-p3478#ps_0_3568|ps_1_1557 Countersunk hole size for both magnets can vary from 4 - 5.5mm QD Sling Mounts are available on both buttstock and main body
Statistics
Likes
0
Downloads
0