Door Ajar-er (Semi-closer)
Description
A gizmo that clips onto the top of a 1cm diameter door hinge nail that, depending on the infill, wall count, and your door's heaviness, may just lightly close or fully shut your door. You may need to lightly tap the door hinge nail out so that about 0.5-1mm of gap is showing under the head so that it can properly clip onto it. I wanted mine to keep the door slightly open so there would be some airflow and my pets could still get through. I used PLA at 40% infill and 2 wall layers. I'm guessing PLA/ABS and other amorphous plastics will slowly deform, so if you can print a crystalline material that won't go crunch that might be best(?).
Statistics
Likes
0
Downloads
0