Betaflight Cetus X alternative canopy model
Description
Modified canopy (v5) of created by comrade Brandon Routh (https://www.thingiverse.com/eezieezi ). I removed the camera mount, increased the stiffening rib - so that the canopy can better "hold" the frontal impact, added a small edge to protect the camera and added a "beard" so that the front part does not fall into the body when struck. Added a "pipe" to output the vtx antenna up. Print by placing the "pipe" of canopy on the table, with small supports around it. Supports inside the "pipe" - exclude! When printing from ABS, the final weight is 2.35 g. which is several lighter than a standard canopy. -------------------------------------------------------------------------------------- Доработал канопу (v5) созданную товарищем Brandon Raetz (https://www.thingiverse.com/eezieezi). Убрал крепление камеры, увеличил ребро жесткости - чтобы канопа лучше "держала" лобовой удар, добавил небольшую кромку для защиты камеры и добавил "бороду" чтобы передняя часть не проваливалась внутрь корпуса при ударах. Добавил "трубу" для вывода антенны vtx вверх. Печатал, поставив канопу "трубой" на стол, с небольшими поддержками у её основания. Поддержки внутри "трубы" - исключать! При печати из ABS итоговый вес получается 2,35 г. что на несколько сотых легча штатной канопы.
Statistics
Likes
0
Downloads
0