Laser Cut Transparent Clear Hotend 3.0mm Rev1.0
Description
Tried Plenty Of Material For Hotend. Like J-Head Peek, Nylon, Pu Carbon Then To All Aluminum . Finally Tried Something Different And Result Is Promising. Heating Time Is Fast And Extrusion Is Somewhere 20-30% More Efficient. Initially With Direct Drive Gear Filament, Extrusion Speed Is 160Mm/Sec In Marlin Setting. Now Just 120Mm/Sec And Still Tuning It Out For Best Print Out. Tried Pulling Out The Filament While It Is Still Hot And Notice That The Filament End Tip Melt Is Shorter Then The Others Hotend. The Heat From The Aluminum Heater Block Does Not Really Transfer Up To The Hotend Body And The Best Of All.... It Is Transparent Clear! Tested Printing With Outer Perimeter At 30, 40,50 & 70Mm/Sec And Result Shows That It Could Be Push Further. The Faster It Print, The Filament Extrusion Flow Is More Smooth. E Motor Is Somehow More Powerful Now And It Need Less Tension For Filament Grip At The Idler. I Was Printing With Diy Abs Filament, Diameter Is 2.55 To 3.05Mm. If Uses Better Tolerance Filament, Result Will Be Even More Better. With Hair Spray And Heatbed At 80°C, Abs Stick Very Well Too! I Will Upload & Share More Video Later. Keep Tune In And Visit Our Site Http://Www.3Dprinter.My Tq! Https://Youtu.Be/0_Kju0Yzy9Q **Updated Dual Extruder Pics. This Is More Easy And Simple Way To Venture Into Mutli-Colour Printing!
Statistics
Likes
23
Downloads
0