Ender 3 V2 Hot End Housing
Description
This is a rough first attempt at a hot end housing for the Ender 3 V2. Pre tap the holes with an M3 tap and for the fan screw bosses, thread the screw in carefully first then back it out and install the fan. Print as it sits on the printer with supports and be careful not to break ribs and locating features inside while removing them. The sizing is slightly off for me and had a slight over shadow that I was able to convince into position. I don't plan on using this long so I'm not super motivated to fix it as I will be going to a different hot end before too long. Feel free to adjust the step file as you see fit.
Statistics
Likes
0
Downloads
1