Mini Plastic Dryer for Filament Extruder
Description
This Is First Version, I Did It After Having Some Problems With Filament Made From Filament Extruder Of My (Designed By Sr. Hugh Lyman) My Goals: It Solves Two Major Problems (In My Opinion): 1. Extrusion Speed Of Filament Is Too Slow (About <20”/Per Minute). 2. Water Bubbles Exist In Filament Fiber (Plastic Pellets Is Always Moist Water ,Slightly Wet) The Second Reason Makes Bubbles On Fiber, It Appears On: Extruding High Speed Or High Temperature (From 190°C To 195°C). Can Not Extrusion High Speed While Using Low Temperatures: About 175°C -185°C, This Case I Called Unripe Extrusion, Plastic Fibers Are Hard, Slightly Grainy If We Look Carefully. (Plastic Tested: Abs, Tpu) Results After Drying: - Extrusion Speed Has Increased, In My Extruder Machine Is > 60”/Per Minute (Maximum In My Extruder, I Think That There May Be Higher) - Filament Fiber: Slick, Smooth And Especially No Bubbles. An Important, All Thing Above Is Only My Personal Opinion, I Hope And I Will Listen To The Opinions Of People, Thanks. Below Is Detailed Of The Mini Dryer : . Heat Band: 250W, Φ30Mm X L. 60Mm . Drying Temperature: 100-125°C . Drying Time: 30’-45’ . Capacity: 1 Kg Plastic . Dimension: W.150Mm X L.160Mm X H.300Mm Cost About: 100Usd Video Link: Https://Youtu.Be/63Xcl10Qmim I Hope It Will Be Useful For Someone By: Thong Nguyetviet
Statistics
Likes
25
Downloads
0