Balloon Boy
Description
This Is My Entry For The #Makeitfloat Challenge. I Named It "Balloon Boy" For Pretty Obvious Reasons. It Uses 3 Stabilizers That Are Printed At 0% Infill (Hollow) At 0.1 Mm Layer Height. The Boat Itself Is Also Printed In This Fashion. The Balloons I Used Were Simple Water Balloons. I Used 5 Pumps Of Air From My Manual Balloon Pump, However, You Will Most Likely Use A Different Pump, So Experiment With Different Values. It Can Hold About 50-60 Pennies Depending On The # Of Pumps On The Balloons.
Statistics
Likes
4
Downloads
0