zero-usb
Description
No more dangling cables... You have to enable USB power on your board first, this might need more work than just flpping jumpers. type B connector gutted from blue printer cable, cut it to length of the plastic terminal, then bend it when you've inserted the terminals, gromet and wires, this will keep it from sliding out. use m3 screws for the cover, vent is covered with thin layer for easy printing, just poke it with 5mm hex or T27 torque bits. For wiring, Pi zero has the following label to match USB pins: 1. 5 Volt for VCC 2. DM for Data - 3. DP for Data + 4. Ground or GND numbering with usb plug facing you starts on top left to right, and bottom left to right or just google the pins :) step file included if you need more space for headers etc. Goodluck!
Statistics
Likes
0
Downloads
0