Raspberry Pi 5 Case (low profile + Active cooler)
Description
Just thought id try and make a case for the Raspberry Pi 5 with active cooler installed. As ive always loved the "Low Profile look" and with the active cooler i had to make sure it was open enough to direct airflow. Dont mind the rubber bands holding it together. i dont have any M2.5 20mm screws to hold it in place as of yet. Will update photos once i have recieved them. (Work in Progress, Still updating and fine tuning, trying to work on a clip on version) whats needed, 4x M2.5 20mm screws Optional: rubber feet for bottom Make sure you print it with the flat side facing down on your printer bed. Hopefully it works for everyone who enjoys this type of case!
Statistics
Likes
0
Downloads
0