Creality Ender 3 S1 LED-Lamp
Description
A clean lamp for the Creality Ender 3 S1. Please only build this thing, if you know how to solder and have some electrical knowledge. Not knowing what you are doing might cause you breaking your printer. Bracket assebly: Screw the three pieces together using two woodscrews through the holes on the side of the brackets. Electrical assembly: Stick 20cm of a white LED-Strip (get on amazon or similar) into the indent on the middle piece. Then solder a capacitor for PWM-stabilization into the cutout of the left bracket. Next, insert a switch (9mm x 11mm) into the cutout on the right bracket. Connect everything to the accessory port on the base of the printer.
Statistics
Likes
0
Downloads
0