Slim Handle 150mm x 40mm x 10mm
Description
I modelled up this slim handle for a 3D printer housing I made. The size of this is 150mm x 40mm by approx. 10mm thick. There are two holes on the ends which ran an M6 tap through. This held two M6 button heads screws which secured the handle quite well. Alternatively a heat set threaded insert should also work. I printed this on Cura and being a small part that will be handled (no pun intended) quite regularly, this was printed with a 100% infill on its side.
Statistics
Likes
0
Downloads
0