Peephole Cover With No-Gap Aperture
Description
I loved the initial design, but the gap left between the two plates was big enough that it actually could be completely bypassed if light was right (featured in photo). So, following the recommendation of a Reddit user on the r/FunctionalPrint post I found this on, I stuck both aperture plates together and cut them apart in the middle on a 45 degree bias, so that each bezel meets the other and fully blocks view. Due to tolerances and somewhat the nature of the design, the plates might not come completely into contact, but that's moot as the peephole needs a flat, direct view to be useable, and this successfully obstructs that.
Statistics
Likes
0
Downloads
0