Extruder Loop

Extruder Loop

Description

This Is An Extruder Named Loop: - For Nema17 Stepped Motor - Standart 50Mm M4 Fixation Holes At The Bottom - Richrap Quick-Fit Compatible - J-Head/E3D Nozzle Buit-In Holder It'S Mainly A Variant Of Http://Www.Thingiverse.Com/Thing:28916 And Greg'S Wade Reloaded What Is Different Then? - Tiltable M4 Idler-Screws Really Open (By 40°) And Have A Stronger Nuts Housing - Filament Is Closer To The M8 Drive Bolt Than Olekdh Version (3.7Mm Center-To-Center) - Oblong Hole For Motor Positionning Are Wider, Allowing To Disangage The Gear For Easier Assembly - Add A Support For Drive Screw Bearing Surface. - It'S Fully Redesigned In Solidworks 2013 See Instruction For More Informations And Changelog Feel Free To Make Suggestions To Improve This Design!

Statistics

Likes

131

Downloads

0