Rock Climbing Nylon Sling Holder Spool
Description
Holder for Nylon slings used in rock climbing. Designed for BlackDiamond 120mm Nylon Sling. <h2>Important</h2> Make sure to file down any sharp edges as a result of the 3d printing process that may damage your sling and cause it lose structural integrity over time. BECAUSE THE MODEL IS LICENSED FREE OF CHARGE, THERE IS NO WARRANTY FOR THE MODEL, TO THE EXTENT PERMITTED BY APPLICABLE LAW. THE COPYRIGHT HOLDERS AND/OR OTHER PARTIES PROVIDE THE MODEL "AS IS" WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESSED OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. THE ENTIRE RISK AS TO THE QUALITY AND PERFORMANCE OF THE MODEL IS WITH YOU. SHOULD THE MODEL PROVE DEFECTIVE, YOU ASSUME THE COST OF ALL NECESSARY SERVICING, REPAIR OR CORRECTION. IN NO EVENT UNLESS REQUIRED BY APPLICABLE LAW OR AGREED TO IN WRITING WILL ANY COPYRIGHT HOLDER, OR ANY OTHER PARTY WHO MAY MODIFY AND/OR REDISTRIBUTE THE MODEL AS PERMITTED ABOVE, BE LIABLE TO YOU FOR DAMAGES, INCLUDING ANY GENERAL, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE USE OR INABILITY TO USE THE MODEL (INCLUDING BUT NOT LIMITED TO DAMAGE TO YOUR SLING OR SUBSEQUENT INJURY SUSTAINED BY YOU OR THIRD PARTIES OR A FAILURE OF THE MODEL TO OPERATE WITH ANY OTHER MODELS), EVEN IF SUCH HOLDER OR OTHER PARTY HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
Statistics
Likes
0
Downloads
0