LACK 3D Printer Tower
Description
Contrary to the traditional LACK Enclosure, this corner piece is strictly for stacking LACK tables on top of each other. There is no interface for adding side panels, doors, or other accessories. The intent of this print is to save space in your 3D printer room/office. Other LACK enclosure builds require several different sized corner pieces based on where they are attached, top/bottom. This design is the same no matter where the corner pieces go. You need 8 corner pieces per table to fit an Ender 3 underneath. Use #8-1/2" flat head screws to secure the corners to the tables (DO NOT tighten the screws too far - you will crack the print). The bottom of your tower will need a piece of plywood/particle board cut to size. The distance between the underside of the table top to the surface below will be approximately 20 inches. My personal tower has 3 LACK tables stacked, so 24 corner pieces total, for 3 printers. I have casters attached to the bottom so I can move the tower around. The top surface of the tower holds my spools using the TUSH system: https://www.thingiverse.com/thing:2047554
Statistics
Likes
0
Downloads
0