Anet A8 LCD back mount for raspberry pi + sencodary board
Description
Remixed to stiffen the plate. I added spacers to mount this a little bit furter away from the lcd screen. This allows cable to go between this plate and the actual lcd backplate for a clean cable managment solution. The squared hole is used to route dupont cables from the GPIO. With extra long spacers you can add a secondary board on the back: in my case that's a small capacitor-based ups for the raspberry pi to shutdown gracefully if power is removed using the printer main switch. Since the board takes 12v in and spits out 5v, I can power it directly form the Anet PSU and I don't need an external buck converter to step-down the voltage for the pi. To be sure the back of the boards will never touch i removed the hex pattern. Note: tolerances are tight.
Statistics
Likes
0
Downloads
0