Gear selection Key for H-pattern shifter mod by Antonyart
Description
Made to fit the V2 tactile H-pattern shifter mod by Antonyart at Thingverse https://www.thingiverse.com/Antonyart Use flush screws for inner ring and this will sit over and hide two screws also. Can be made to your preferred settings, but I used PLA at 210° at 50mm/s infill speed/movement speed and printer speed (all 50) No.supports needed but I suggest high resolution... she'll thickness and infill can be whatever but I'd do at least 2 on she'll Bottom.layer 3 and top layer 4 in case you want to sand flat. I haven't chamfered the edge, but if you want to then re-upload and credit me for my work, thay would be fine if it will improve mods for the community. My 3D printed G29 mod list is so far -Tactile H-pattern mod V2 with top section at 115% z Axis by Antonyart -New shifter knob with 8 x 8mm Steal Ball bearings inside for weight (csnt remember artist but it was a Mazda 3 knob with top cap) -4mm spring pre-tensioner inside shifter for tighter gear selection -Pedal extension mod to raise throttle pedal. Let me know if you'd like me to email you my complete file list for newbs
Statistics
Likes
0
Downloads
0