Simple RC Boat
Description
This Is A Simple 3D Printed Rc Boat, Optimized For 0.4Mm Nozzles. The Entire Build Can Be Done In Only 3 Hours (Including Print Time)! The Boat Uses Very Simple And Common Electronics: - Any Transmitter And Reciever - Small Standard Brushed Motor (See Pictures) - Small Servo Like This One: Http://Www.Hobbyking.Com/Hobbyking/Store/__9392__Turnigy_Mg90S_Digital_Metal_Gear_Servo_1_8Kg_13_4G_0_10Sec.Html - An Esc Made Out Of An Old Servo Controller (Http://Www.Instructables.Com/Id/Jury-Rigging-A-Servo-To-Drive-A-Low-Voltage-Motor/#Step1) To Make The Boat Water Tight, Several Layers Of Abs Slurry Were Applyed On The Inside And Outside (Http://Www.Instructables.Com/Id/100-Warp-Free-Makerbot-3D-Printing/Step1/Put-Abs-Scraps-And-Acetone-In-A-Jar/) I Hope You Enjoy This Little Project, And Be Sure To Check Out My Profile For More Rc Stuff!
Statistics
Likes
195
Downloads
0