Ender 5+ Dual 4010 Blower Cooling Fan Upgrade with BLTouch Mount for Creality Ender 5 Plus
Description
FOLLOW the print instructions on the original design that I remixed. I made a new version wide enough for the Ender 5 Plus Carriage Plate. You need his files as well. THIS IS NOT A CLEAN MODEL. IT REQUIRES SANDING AND CUTTING AFTER PRINTING. IT IS A WORK IN PROGRESS. This is a slightly edited version for Ender 5 Plus. My model wasn't perfect and required a bit of sanding/clipping to get it all to work but the duct design is great and I have seen a lot of improvement in my stringing and bridging with it. Great design! I had to cut sections for the ends of the belts as it interfered. I also cut part of the duct away above where the zip tie goes as it was a tight fit and I wasn't getting much airflow through the heatsink once I mounted it to the carriage plate. I used 2 WINNSINN 4010 24V blowers and they seem to move a decent amount of air. Biggest difference is that the dual sided airflow is great for bridging in all directions which is where I was having issues. CLEAN BRIDGES OUT TO 150mm! Thanks again to @cdsmakestuff! https://www.thingiverse.com/cdsmakestuff/designs I have since removed the turbo fan cover because of noise/airflow. I may edit the model so it doesn't require cutting and sanding and reprint in ABS at some point but right now it is working very well. WORK IN PROGRESS. Special thanks to @zanek012 https://www.thingiverse.com/zanek012/designs for his Ender 5 Plus model (https://www.thingiverse.com/thing:4556594) which I used as reference for the carriage plate.
Statistics
Likes
0
Downloads
0